K-Strip Sheet Cavity fix is a cavity closer and a support member for the bottom edge of the sheet.
The K-Strip Sheet Cavity fix has a unique design that encompasses two products into one saving time and money.
The K Strip Sheet Cavity Fix is a Cavity Closer as well as a support member designed to take the weight of the sheet while it is being fixed in position. The K Strip provides a straight edge for the bottom edge of the sheets as well as providing a fixing point.
It can be used with Fibre cement sheets and Ply sheets.
The Labour saving along with providing an accurate bottom edge for the sheet makes the K Strip the best choice available when installing a sheet product.
It's ridged design provides long term support for the bottom edge of the sheet to reduce the risk of it being broken when hit or knocked.
PRODUCT CODE: EB100
Comes in 2.2 metre lengths
Sheet installation
Simply fix it to the bottom plate after the building wrap has been installed using 40x2.5mm hot dip galv clouts @ 400mmcrs
Allow for the cladding to lap 50mm over the concrete slab or floor structure as per E2 External Moisture or as specified
Fit the cavity battens as specified. Check out the back of the batten over the K Strip to ensure a flat surface
Ensure the bottom edge of the sheet is painted/sealed as per manufactures specifications
Then apply a continuous 5mm bead of sealant/adhesive to the bottom corner and a bead near the top of the support face that the sheet fits against. Ezy Build Products recommends using Bostik Seal n Flex 1
Lift the sheet into place and fix off as per manufacture's specifications. The sheet can be fixed to the K Strip @ 400mmcrs with 20mm s/s countersunk screws
Remove excess sealant from the bottom edge
Move on to the next sheet
https://www.branz.co.nz/appraisal-codemark-certificates/ezybuild-k-strip-and-concealed-vent-cavity-closers/
TIP: For best results EzyBuild recommends Bostik MS Safe Seal for
K-strip gluing and sealing.